BCDMP - TM-30 PART B
- MSDS: BCDMP
- Manufacturer: WESTPAC PRODUCTS CO INC
- Product Name: TM-30 PART B
- National Stock Number: 9999-00N000005
Product Identification
Product ID:TM-30 PART B
MSDS Date:06/11/1987
FSC:9999
NIIN:00N000005
Kit Part:Y
MSDS Number: BCDMP
Responsible Party
OAKLAND, CA 94621
US
Emergency Phone: (803) 572-3091
Info Phone: 415-632-3778
Cage: 5R869
Contractor
Telephone: 415-632-3778
Cage: 5R869
Ingredients
NO INGREDIENT FOR THIS FORMULATION_INGREDIENT
Hazards
Effects of Overexposure:PROLONGED OR REPEATED CONTACT MAY CAUSE EYE
IRRITATION, ALLERGIC SKIN IRRITATION, OR DERMATITIS.
First Aid
First Aid:CAUTION! THIS MATERIAL CONTAINS AN AMINE. IN CASE OF SKIN
CONTACT, WASH IMMEDIATELY WITH SOAP AND WATER. FOR EYES, FLUSH WITH
PLENTY OF WATER AND CONSULT A PHYSICIAN IMMEDIATELY. WASH CLOTHES
BEFORE R E-USE.
Fire Fighting
Flash Point Method:CC
Flash Point:306F,152C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:AVOID HEAT, OPEN FLAMES, AND ELECTRICAL
SPARKS.
Accidental Release
Spill Release Procedures:SOAK UP IN ABSORBENT AND FLUSH WITH PLENTY OF
WATER.
Handling
Handling and Storage Precautions:WARNING! MAY CAUSE SKIN SENSITIZATION
OR OTHER ALLERGIC RESPONSES. CAUSES EYE IRRITATION.
Other Precautions:USE ONLY WITH ADEQUATE VENTILATION. AVOID SKIN
CONTACT AND BREATHING OF VAPORS.
Exposure Controls
Respiratory Protection:IN CONFINED AREAS USE ORGANIC VAPOR RESPIRATOR-
NIOSH APPROVED.
Ventilation:LOCAL EXHAUST-PREFERABLE; MECHANICAL(GENERAL)-ACCEPTABLE
Protective Gloves:YES
Eye Protection:SPLASH-PROOF GOGGLES
Supplemental Safety and Health
THIS IS A TWO-PART PRODUCT. SEE P/N IND A UNDER SAME NSN.
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:392F,200C
Vapor Density:1
Spec Gravity:1.03
Evaporation Rate & Reference:<1
Solubility in Water:MISCIBLE
Appearance and Odor:CLEAR AMBER; AMINE ODOR SLIGHT.
Percent Volatiles by Volume:NIL
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS AND EPOXY RESINS
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Conditions to Avoid Polymerization:STRONG ACIDS AND EPOXY RESINS
Disposal
Waste Disposal Methods:INCINERATE UNDER APPROVED CONDITIONS OR BURY IN
APPROVED LANDFILLS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.